Keep Your Flair in Tip Top Shape
Cleaning Your Flair 58x
1. Dissasemble and detach
locking hook, then use stem
to remove plunger
3. For more thorough
cleaning, place a cup
beneath your Flair 58x
and ush with cool water
before wiping
2. Use damp cloth to wipe
the inside and bottom of
the brew head. Also wipe
the plunger
Before cleaning, always ensure that your brew head has cooled and never immerse the brew
head in water. If you have upgraded to the electrical system, ensure this is o before cleaning.
No Soap Needed!
Keep Outside
Surface &
Wires Dry!
See our online “Safety and Instructions Guide” via the QR code for more information.
Flair’s World-class customer service is a snap away
Troubleshoot Your Flair 58x
Reach Us Directly: https://airespresso.com/contact/
GET PLUGGED IN
Upgrading Your 58x to Electric Preheating
THERMAL MANAGEMENT FOR ANY ESPRESSO
Preheating Your Flair 58x
(a) Place empty cup under your Flair 58x to catch preheat water (b) Lower lever so valve
plunger is at bottom of brew cylinder (c) Fill brew cylinder with water just o the boil
(d) Allow to sit for at least 45 seconds then (e) raise lever slowly, allowing preheat water
to pass through valve plunger and into cup (f) Repeat as necessary
Your Flair 58x is manual and non-electric, and must be preheated with either hot water
or steam, prior to brewing. We suggest using water just o the boil and the method
described below.
Add Just
Boiled Water
Let Sit for
45 Seconds
Your Flair 58x is electric capable, and can be upgraded to the
Electric Preheat System by purchasing Flair’s Preheat Controller
System.
Once purchased, simply remove the cap from the back of the
brew cylinder, plug in your preheat controller, and you’ll be
ready to go.
The Preheat System allows you to select one of three brew
temperatures to correspond to dierent roast levels, light,
medium and dark.
But, no matter where you go, your Flair 58x will maintain it’s
ability to brew o the grid.
To Next Page
Loading...
