27
TROUBLESHOOTING
If nothing gets recorded, but you could hear the changes while recording:
Make sure that MUTE & HOLD isn't active on that particular track. HOLD has to be unlit
in order to record, otherwise you're only performing your change, but not recording it –
which is great, when intended ;) And MUTE states should be obvious.
If TAKT still isn't recording:
Check if the gatetime and velocity (only relevant for Midi or if CV is connected to Velocity
of a VCAS) knobs are in their middle position. Just move both knobs a few millimetres
back and forward. Usually that should quickly become part of your muscle memory, but
it can be confusing sometimes, especially when starting off.
I'm playing several notes but only a few get recorded:
Make sure that resolution is set to 16th notes, which is always a good starting point
anyway..
My recording sounds wonky:
Either the resolution is set to max (BEAT pot fully cw = TICK) hence you're recording
unquantised, or the BEAT pot is set to triplets (the morning hours). Or you've accidenti-
ally pressed the offbeat button.
I can't delete the pattern:
Make sure the sequencer is not running.
I deleted some notes, but something is still off?
You probably deleted notes only (CLEAR & lowest row - the track buttons - only dele-
tes the note). Hold CLEAR and press the according button in the second lowest row
(the function buttons) in order to initialise that track.
I don't know how to exit a menu:
Press TEMPO or NOTE (both left)!
The sensors play by themselves or interfere because I accidentally trigger
them when wiring:
Press and hold the SEN-SET button until it flashes. Now the sensors are switched off
and cannot trigger any notes. To activate, press the button again until the flashing
stops.
To Next Page
Loading...
