To Next PageTo Next Page
Need help?Do you have a question about the FLARM F6 series and is the answer not in the manual?
General| Brand | FLARM |
|---|---|
| Model | F6 series |
| Category | Security System |
| Language | English |
Unit reports aircraft in vicinity, even if not a threat. Signals threat intensity.
Unit signals immediate threat with visual and audible warnings; threat level shown by LEDs.
Pilot can suppress visual and acoustic warnings for five minutes.
Instructions for inserting and removing microSD cards for firmware and data updates.
Guide to updating the unit's firmware via microSD card, including file requirements.
Steps to update the obstacle database using a microSD card and PC software.
How device configuration is processed via flarmcfg.txt file on microSD card.
Details on the sequence of events and LED indications during unit power-on.
Troubleshooting guide for faults indicated by flashing LEDs during start-up or operation.
Explanation of the green Status Display LEDs: Receive, Send, GPS, and Power.
Changing the audio volume level via brief button presses.
Switching between Nearest and Collision modes with a longer button press.
Activating a receiver self-test to check detection of other FLARM units.
Temporarily suppressing optical and acoustic warnings with a double push.
Performing a system re-boot or resetting to factory settings via long button presses.
How the 12 bicolour LEDs on the compass rose indicate threat bearing and level.
How the four red LEDs indicate vertical bearing relative to the horizontal plane.
How closest aircraft are shown in green in Nearest-mode without warning.
