www.flash-butrym.pl Strona 2
Congratulations on purchasing this 200W moving Beam Light
Thank you for extending your trust in our technology!
For reasons of safety and approval(CE) the personal reconstruction and/or modification of this product is prohibited.
Please observe that damage caused by modifications performed manually to this device is not covered by the
warranty.
This product leaves our works in a perfect condition. Please observe all notes in these operating instructions to warrant
this condition and the safe operation of the product!
Any damage caused as a result of the non-compliance with these operating instructions leads to the expiration of any
warranty claim. The manufacturer does not accept liability for any damage to property or for personal injury resulting
from the improper handling of the product, or non-observance of the operating instructions.
Store these operating instructions in a safe place for later reference and pass them to any new holder when selling
or lending or leaving this device in the hands of any other party.
Notes on safety
1. Before Operation
Prior to the initial operation of this product, please do the followings:
-Read these operating instructions with great care;
-Study and observe all instructions carefully;
-Ensure that everybody and anybody involved in the installation, operation, transport and storage of this product is
suitably qualified;
-Verify whether any visible damage was caused during transport. lf the power cord, housing or the light are damaged,
do not operate the device; contact your specialized dealer immediately.
2. Supply Voltage, Mains Cord and Connection to Mains
The handling of supply voltage, mains cords and connections to mains calls for particular care considering the risk
from a life-threatening electric shock, the risk of fire and the risk of short circuits please observe the following notes
in particular:
Products operating on supply voltage should be kept out of the reach of children. Therefore ensure the permanent
supervision if children are in the immediate vicinity of the product!
For commercial facilities the regulations on the prevention of accidents of the respective trade association must be
observed. The operation of this equipment at schools, training facilities, and hobbyorself-help workshops must be
supervised responsibly by trained personnel.
Check the product regularly for any damage to the mains cord! Should you discover any damage to the mains cord,
do not operate or disconnect this product! Secure the product against accidental operation and contact your
specialized dealer.
Always separate the product from mains by holding the mains plug by the handling surface. Never disconnect by
holding the line cord ! Be sure to connect the product to power supply with appropriate parameters!
Always ensure during installation, operation, transport and when storing the product that the mains cord is not exposed
to possible mechanical damage, or damage caused by humidity, fluids, heat or cold
The products cable entry must not be exposed to stress from pull! Create the mains connection once the product has
been installed only .Always connect the mains plug last!
The product must only be connected to a proper outlet of the public supply grid. Connect the mains cord to suitable
outlets only ! Use entensions cords in compliance with specifications only! Do not allow the mains cord to come into
contact with other cords!
Ensure during installation, operation, transport and storage that none of the cables are freely exposed!
Never touch the mains cord, mains plug and outlet with wet or damp hands!
When not using the product, and prior to cleaning always disconnect the product from mains! To do so, hold the mains
plug by the handling surface and never pull the mains cord!
Never connect the device to dimmer pack!
3. Housing
To Next Page
Loading...