Full System flush (weekly)
It is not recommended to store paint in the machine for longer than 24hrs
1. Ensure that the water tank has sufficient water for the cleaning operation.
2. Position the machine where it can be flushed and cleaned.
3. With the supplied clean drum, fill with clean water and add Kombi Klean.
4. Position the nozzle assembly over a drain or suitable container.
5. Place probe from paint drum into clean water drum and flush
6. With the paint/water change over tap in the ‘paint’ position (Fig 17), turn on the
pump. Allow the water to spray through the nozzle until the drum is empty.
7. Remove the bayonet cap complete with the nozzle tip and filter. If necessary,
rinse to clean.
8. Refit the bayonet cap complete with the nozzle tip and filter
9. Using a damp cloth lean any paint overspray from the following:
A. Line forming discs and guide shafts. Build up of paint on the guide
shafts will make line width adjustment more difficult
B. Generally clean and remove paint overspray or spills from the machine
Maintenance
12
To Next Page
Loading...