FLEET Kombi Ranger - Page 16

TROUBLESHOOTING
If the Kombi Ranger line marker is not producing the perfect line, the
table below is to help diagnose and remedy simple issues. The main
cause for failure is inadequate cleaning/flushing. It is imperative to keep
the paint system free from dried paint particles.
Note: These procedures presume that there is sufficient Fleet paint
in the paint tank.
Troubleshooting
15
No
.
Issue Cause Remedy
1 Intermient
line/
pressure
Gauge
ickering
Airlock in paint system A. Fill water drum with clean water
B. Insert draw hose and purge water
through the pipework.
C. Once airlock is clear remove water
drum and replace with the paint
drum.
2 Line striping 1.Nozzle p
contaminated
2. Insucient
pressure
A. Remove the nozzle and clean in Fleets
Nozzle Tip cleaner sonic bath.
B. Replace with new nozzle.
Increase pressure using the pressure adjust-
ment knob on the control panel
3 Low pump
pressure
Low Baery Charge Use baery monitor to check baery status.
Recharge baery
4 No machine
power
1.Low baery
charge
2. Fuse blown
Use baery monitor to check baery status.
Recharge baery.
Check blade fuse and replace if necessary
5 Pressure
increasing
Blockage A. Check nozzle and top hat lter for res-
idue, clean and replace.
B. Replace with new nozzle and lter.