CS 62 18.0-EC

Contents

Symbols used in this manual . . . . . . . . . 16

Symbols on the power tool. . . . . . . . . . . 16

For your safety . . . . . . . . . . . . . . . . . . . . 16

Noise and vibration. . . . . . . . . . . . . . . . . 19

Technical specifications . . . . . . . . . . . . . 19

Overview . . . . . . . . . . . . . . . . . . . . . . . . 20

Instructions for use. . . . . . . . . . . . . . . . . 21

Maintenance and care . . . . . . . . . . . . . . 26

Disposal information. . . . . . . . . . . . . . . . 26

-Declaration of Conformity. . . . . . . . . 27

Exemption from liability . . . . . . . . . . . . . 27

Symbols used in this manual

WARNING!

Denotes impending danger.

Non-observance of this warning may result

in death or extremely severe injuries.

CAUTION!

Denotes a possibly dangerous situation.

Non-observance of this warning may result

in slight injury or damage to property.

NOTE

Denotes application tips and important

information.

Symbols on the power tool

Before switching on the power

tool, read the operating manual!

Wear goggles!

Wear ear protection!

Disposal information for the old

machine (see page 26)!

For your safety

WARNING!

Before using the power tool, please read

and follow:

- these operating instructions,

- the “General safety instructions” on the

handling of power tools in the enclosed

booklet (leaflet

no.: 315.915),

- the currently valid site rules and the

regulations for the prevention of

accidents.

This power tool is state of the art and has

been constructed in accordance with

the acknowledged safety regulations.

Nevertheless, when in use, the power tool

may be a danger to life and limb of the user

or a third party, or the power tool or other

property may be damaged.

- The power tool may be operated only if it

is as intended,

- in perfect working order.

Faults which impair safety must be repaired

immediately.

Intended use

The plunge saw CS 62 18.0-EC is designed

Ó for commercial use in industry and trade,

Ó for lengthwise and cross cuts with

a straight cutting path,

Ó for cutting solid wood and board

materials such as chipboard and wood-

core plywood and MDF boards up to

a maximum thickness of 62 mm,

Ó for use with circular saw blades which

FLEX offers for this machine.

Not permitted are

Ó the use of HSS saw blades and cutting-

off wheels,

Ó stationary use as a circular bench saw,

Ó use outdoors in the rain,

Ó use in potentially explosive areas.

Flex CS 62 18.0-EC - Page 316

Table of Contents

Other manuals for Flex CS 62 18.0-EC

Related product manuals