Flexim FLUXUS F502TE - Data Logger; Activation;Deactivation of the Data Logger; Setting of the Storage Rate; Configuration of the Data Logger

14 Data logger
FLUXUS F502TE 14.1 Activation/Deactivation of the data logger
101
UMFLUXUS_F502TEV1-5EN, 2020-05-29
14 Data logger
The transmitter has a data logger which stores the following data during the measurement:
• date
• time
• measuring point number
• pipe parameters
• fluid parameters
• transducer data
• sound path (reflection or diagonal arrangement)
• transducer distance
• damping factor
• storage rate
• physical quantity
• unit of measurement
• values of the totalizers
• diagnostic values
In order to store the data, the data logger has to be activated.
The available data logger can be displayed.
14.1 Activation/Deactivation of the data logger
• Select the program branch Output Options.
• Press ENTER until Store Meas.Data is displayed.
• Select yes to activate the data logger or no to deactivate it.
• Press ENTER.
14.2 Setting of the storage rate
The storage rate is the frequency to transmit or store measured values. If the storage rate is not set, the storage rate
selected previously will be used.
The recommended storage rate is 4 s.
• Select a storage rate or EXTRA.
• Press ENTER.
This display will only be indicated if Store Meas.Data and/or Serial Output are activated.
• Enter the storage rate if EXTRA was selected.
• Press ENTER.
14.3 Configuration of the data logger
• Select the menu item Special Funct.\SYSTEM settings\Storing.
• Press ENTER.
Output Options\...\Store Meas.Data
Output Options\...\Storage Rate
Output Options\...\Storage Rate\EXTRA
Special Funct.\SYSTEM settings\Storing