8 Start-up
8.7 Date and time FLUXUS F502TE
2020-05-29, UMFLUXUS_F502TEV1-5EN
70
8.7 Date and time
The transmitter has a battery-powered clock. Measured values are automatically stored with date and time.
• Select the menu item Set Clock.
• Press ENTER.
The current time is displayed.
• Select ok to confirm the time or new to adjust it.
• Press ENTER.
• Select the character to be edited with . Edit the selected character with .
• Press ENTER.
The new time is displayed.
• Select ok to confirm the time or new to adjust it again.
• Press ENTER.
After the time has been set, the date is displayed.
• Select ok to confirm the date or new to adjust it.
• Press ENTER.
• Select the character to be edited with . Edit the selected character with .
• Press ENTER.
The new date is displayed.
• Select ok to confirm the date or new to adjust it again.
• Press ENTER.
8.8 Instrument information
• Select the menu item Instrum. Inform. to get information about the transmitter.
• Press ENTER.
The type and the serial number of the transmitter are displayed in the upper line.
The max. available data logger will be displayed in the lower line (here: 18 327 additional measured values can be stored).
• Press ENTER.
The firmware version of the transmitter is displayed with the date in the lower line.
• Press ENTER.
Special Funct.\SYSTEM settings\Set Clock\TIME
Special Funct.\SYSTEM settings\Set Clock\DATE
Special Funct.\Instrum. Inform.
F502TE -XXXXXXXX
Free: 18327
V x.xx dd.mm.yy
To Next Page
Loading...
