FLIR Ariel CM-3102 - Connecting the Camera to the Network; Configuring the Units Initial IP Address; Figure 13: DNA Discovery Window

Installing and Connecting the Camera
22
Ariel CM-3102 User and Installation Guide
December 12, 2018
5.4.1 Connecting the Camera to the Network
To view and configure the camera via a LAN, you must attach the camera via the network switch or
router to the same subnet (network segment or VLAN) as the computer that manages the unit. It is
recommended to use FLIR’s DNA utility to search for and change the camera’s initial IP address.
5.4.2 Configuring the Unit’s Initial IP Address
Use the FLIR DNA utility to discover the unit on the network and to set the unit’s initial IP address.
 If the camera is managed by FLIR’s Horizon or Meridian VMS and is configured as a DHCP
server, Horizon or Meridian automatically assigns the camera an IP address. Configure the
camera with DHCP-enabled.
 If the camera is managed by FLIR’s Latitude VMS, manually enter its IP address in the DNA
utility.
Note:
1. It is possible to set the IP address without changing the subnet.
2. The unit and the PC must be physically connected on the same network segment.
3. The PC browser version must be 32-bit Internet Explorer (IE 10 and above).
To manage the camera using Horizon, Meridian, or on a DHCP-enabled network
Download the DNA Utility from the website (see 2.3 Downloading Product Information from the
FLIR Website).
Run the dna.exe file by clicking the icon. The DNA application opens and the device is
displayed in the window.
Figure 13: DNA Discovery Window