FLIR Ariel CM-3102 - Figure 37: Date & Time Screen

Accessing the CM-3102 via a Web Browser
December 12, 2018
Ariel CM-3102 User and Installation Guide
39
To set the zoom control
In the Zoom Control section, move the slider to the desired zoom between Wide (1.00) to Tele
(3.00).
To set Auto Focus
In the Focus Control section, click Start. Auto Focus is adjusted.
Note:
If the Auto Focus function does not produce a clear picture, do the following:
Click Reset in the Reset Lens section.
Click Start in the Focus Control section. The image refocuses.
Continue with the lens setup procedure.
To manually set the focus
In the Focus Control section, move the slider to the desired focus between Far (1) to Near (100).
From the Step drop-down list, select the number of steps to set the focus: 1, 2, 4, 8, 16, 32, 64,
or 128.
To set the Zoom Trigger Control
In the Zoom Trigger Control section, from the Zoom Trigger drop-down list, select ON or OFF.
This setting determines if the camera will automatically focus itself after the zoom has been
changed.
To revert to the previous settings
In the Restore Position section, click Start. The previous settings are restored.
Note:
After clicking the Restore Position Start button, it is necessary to click the One-Push AF Start
button in the Focus Control section to refocus the lens.
Basic Configuration
The Basic Configuration tab includes the following screens:
Date & Time
Audio
(CM-3102-11-I only)
Firmware
Basic Operations
OSD
6.3.1.2.1 Date & Time
The current time is displayed in the Current Camera Time text box. To set the date and time, select
Basic Configuration > Date & Time. The Date & Time screen is displayed.
Figure 37: Date & Time Screen