3.15 MOUNTING MNVD TO A WEAPON
WARNING:
Always make sure your firearm is unloaded before you place the equipment on the firearm.
Always verify that the chamber is empty, especially if you stop the procedure and resume later. Safe
handling rules should be followed at all times.
WARNING:
If equipment is mounted too far to the rear of a weapon, the eyepiece can injure the shooter’s brow.
Shooting at an uphill angle also increases this risk, because it shortens the distance between the
brow and the rear of the equipment. When mounting your equipment, we recommend positioning it
as far forward as possible.
With hard-recoiling rifles, serious injury or even death can result from eyepiece impact when
discharging the firearm.
THE USER ASSUMES ALL RESPONSIBILITY AND LIABILITY FOR HAVING THE FLIR EQUIPMENT
PROPERLY MOUNTED TO A FIREARM AND USING THE FLIR EQUIPMENT PROPERLY. ALWAYS CHECK
THE CONDITION OF YOUR MOUNTING SYSTEM PRIOR TO USING YOUR FIREARM.
To mount the MNVD to a weapon, use an optional Quick-Release Picatinny Mount adapter (QRM). This
small arms adapter allows the MNVD to be mounted on a weapon with Picatinny MIL-STD-1913 rail.
For more information on the use of an QRM, see the QRM User Manual.
To Next Page
Loading...
