FLIR DNR400 SERIES - Connecting a PTZ Camera (DNR400 Series); Connecting a FLIR PTZ camera to the system; To connect a PTZ camera to the system via RS485

DDNS Setup (Advanced)
20
Free DDNS service is available as an optional connectivity method to connect to your sys-
tem over the Internet.
Note
Except where noted, the instructions in this section are the same on PC or Mac.
20.1 Accessing your System within a Local Network (LAN)
You can connect to your system through using the Client Software through the local area
network (LAN). It is recommended to confirm connectivity over a local network before set-
ting up your system for DDNS connectivity.
Note
To complete the steps below, your computer must be on the same network as your system.
20.1.1 Step 1 of 3: Connect your System to Your Router
1. Power off your system by disconnecting the power adapter.
2. Connect an Ethernet cable (included) to the LAN port on the rear panel of the system.
Connect the other end of the Ethernet cable to an empty LAN port (usually numbered
1~4) on your router.
3. Reconnect the power adapter to power the system back on.
0
Router
Internet
Security System
(may not be exactly as
shown)
(not required for
local viewing)
Computer
#LX400022; r. 1.0/16695/16698; en-US
154