Rear Panel (DNR400 Series)
5
1. Power input: Connect the included AC power cable.
2. On / Off switch: Turns the NVR on or off.
3. PoE Ports: Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
5. VGA: Connect a VGA monitor (not included) to view the system interface.
6. MIC IN/OUT: RCA input and output for 2–way audio.
Note
Audio-enabled IP cameras (not included) are required to use audio recording. You cannot record
audio from the input (e.g. microphone) connected to the MIC IN port.
7. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
8. RS232: Service only; not supported.
9. USB port(s): Connect a USB mouse (included) or USB thumb drive (not included) for
data backup or firmware updates.
10. Alarm block: Connect alarm/sensor devices (not included).
#LX400022; r. 1.0/16695/16698; en-US
7
To Next Page
Loading...
