FLIR identiFINDER R200 - A Word about Batteries

1.3 Before First Use
1.3 Before First Use
Charge the battery of the FLIR identiFINDER R200 after unpacking and before first use.
Read this manual and become familiar with the FLIR identiFINDER R200.
Time and timezone must be properly set in order for the FLIR identiFINDER R200 to operate cor-
rectly. See "Device" on page31for more on setting the clock and timezone.
A Word about Batteries
The FLIR identiFINDER R200 comes equipped with an internal (non-accessible) battery that is the
primary source of energy to power the detector and that requires charging using the USB 2.0 mini-B
cable.
The IP67-rated battery door (accessible through the threaded port, right-side of detector) provides for an
external battery that is used as a backup source of energy should the internal battery drain below a level
that will power the detector.
1-7 R200 3/10/2017__1:38 PM