FLIR identiFINDER R200 - Bluetooth

Bluetooth
This information should be detailed in operating instructions for the device.
Bluetooth
To set up the FLIR identiFINDER R200 for a Bluetooth connection, perform the following steps.
Device Settings
Ensure the FLIR identiFINDER R200 is set as follows:
USB COM
Figure 3-14 Set this to "On".
Navigate to the "Bluetooth" menu:
Figure 3-15 Navigate to Bluetooth via "Device", "Connect", "Bluetooth"menu
sequence.
Select either SPP or BLE mode
For Apple
®
, select BLE (iOS),
and for Android
®
, SPP (Adrd)
Selecting BLE (iOS) or SPP (Adrd) displays the following until the connection is
established:
R200 3/10/2017__1:38 PM 3–58