FLIR identiFINDER R200 - 4.5 Acquiring Spectra from a Remote Platform via USB

4.5 Acquiring Spectra from a Remote Platform via USB
Figure 4-10 AutoMode may be set to either "On", or "Off". This is a standard configuration and may not achieve
desired results.
4.5 Acquiring Spectra from a Remote Platform via USB
Connect the FLIR identiFINDER R200 to a computer (laptop, notepad, etc.) via a USB cable and the
detector may be used to stream data to the remote platform (devices connected via USB).
Analysis of the data acquired may be accomplished over the USB, hard-wired connection.
Data acquired in this fashion may be captured by the remote source for purpose of consideration for
example, or, perhaps, dissemination (e-mail, remote desktop, texts, etc. via a connection with a phone).
The method for interface with a local computer is achieved by porting to a USB2.0 connection on the
computer that the FLIR identiFINDER R200 is connected to via its charging/data transfer port.
4-67 R200 3/10/2017__1:38 PM