FLIR identiFINDER R200 - Connecting to a Local Computer

Chapter 6 Connecting to a Local Computer
6.1 Plugging and Unplugging
The method for interface with a local computer is achieved by porting to a USB2.0 connection on the
computer that the FLIR identiFINDER R200 is connected to via its charging/data transfer port.
Figure 6-1 Connection port (USB 2.0 Mini B) for charging and data transfer is located behind the port
cover at the base of the detector. Note the orientation of the cabling connector (wide-side of the con-
nector is imprinted with the USBsymbol and is aligned with the face (top) of the detector); this is to
ensure proper docking with the port.
The opposite end of the cable is a standard USBconnection, and should be connected to the computer.
6 - 73 R200 3/10/2017__1:38 PM