FLIR identiFINDER R300 - Connection for Uploading FLIR Identifinder R300 Data to a Remote Server

FLIR Detection 9. Sending Data to a Remote Server
FLIR identiFINDER R300
Cell Phone with Dial-Up
Networking Support
Computer
connected to
the Internet
Internet
Server
Figure 225. Connection for uploading FLIR identiFINDER R300 data to a remote server
• your phone carrier provides the necessary infrastructure and data plan.
To set up the connection you need the correct credentials and access information provided by your
cell phone carrier, in particular
User Name
The user name and
Password
the password for the dial up connection. Both can be omitted with some carriers which use
other means for authentication, for example your SIM card.
Connection String
Settings specifying the connection, for example
+CGDCONT=1,”IP”,”web.example.com” .
Phone Number
The number for data connections, for example *99***1# .
Ô
To congure your FLIR identiFINDER R300 for sending data to a remote server…
These steps are required once for a given combination of cell phone carrier and remote
server.
1. Collect the required setup information (see above) from your cell phone carrier or your IT
administrator.
2. Enter the setup information into the FLIR identiFINDER R300 (see 6.24, p. 149)
3. Enter the operator’s (your) name and voice phone in the FLIR identiFINDER R300 (see 6.27,
p. 153) so they can be included in reports to be sent.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 221