FLIR Detection 2. Operating the FLIR identiFINDER R300
You increase the component with + and decrease it with - . In the example shown here, you
edit the year of the date since it is the selected component.
Now you need commands to select the other components of the value (see 2.2.1, p. 35). You can
reveal them with
Skip mapped to L (Figure 24, p. 41).
Figure 24. Changing Combined Values: Selecting components.
Press Left or Right to select the component you want to edit.
To get the commands for editing back, press
Skip until + or - reappear.
After you inished editing all components, press
Skip until you see the Accept command, then
press
R .
In case you change your mind, you can
Cancel editing the value with R (Reveal the command
with
Skip if necessary). The value in effect before you started editing with Select will be reestab-
lished.
Pressing
I for a moment also cancels editing.
Do not press I for too long. That would power down your FLIR identiFINDER R300.
2.2.5 Changing Numerical Values
A lot of settings are numerical values, often with a immutable unit.
Several commands (Figure 12, p. 35) are available for editing numerical values. One of the number’s
digits is always selected (Figure 25, p. 42), that is, editing commands are applied to this digit. If you
start changing a number with
Select (see 2.2.3, p. 37), the rightmost (least signiicant) digit is
selected.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 41
To Next Page
Loading...
