FLIR InfraCAM - Controls & Functions

5.4 Controls & functions
General
The camera has the following controls:
■
Four push-buttons
■
One navigation pad
■
Two triggers
Explanation
This table gives an explanation to the figures on page 13 and 14:
FunctionsButton or trigger
The left selection button has the following context-
sensitive functions:
■
Menu
■
Select
■
Options
■
Cancel
■
Delete
Left selection button
Push to go between camera mode and archive mode.Camera/archive button
The right selection button has the following context-
sensitive functions:
■
Man/Auto
■
Close
■
Open
■
Overview
■
OK
■
Delete
■
Restore
Right selection button
■
Push the power button to start the camera.
■
Push and hold the power button for more than 0.5
seconds to stop the camera.
Power button
■
Push up/down or left/right to navigate on menus
and in dialog boxes.
■
Push up/down to change a value.
■
Push left/right to select a menu command in a
menu.
Navigation pad
■
Pull the top trigger to start the laser pointer.
■
Release the top trigger to stop the laser pointer.
Top trigger
Pull and release the bottom trigger to save one image
to the camera memory, or SD Memory Card (depend-
ing on camera model).
Bottom trigger
NOTE
The laser pointer may not be enabled in all markets.
5
Publ. No. 1558299 Rev. a200 – ENGLISH (EN) – February 12, 2007 15
5 – Camera parts