FLIR InfraCAM - Charging the Battery

8.3 Charging the battery
NOTE
You must charge the battery for four hours before you start the camera the first time.
General
You must charge the battery when the message Battery voltage is low! is displayed
on the screen.
Do one of these procedures to charge the battery:
■
Use the combined power supply & battery charger to charge the battery when it
is inside the camera.
■
Use the combined power supply & battery charger to charge the battery when it
is outside the camera.
■
Use the stand-alone battery charger to charge the battery (The stand-alone battery
charger is an item that is not included in the standard package.).
SEE ALSO
For information how to charge the battery, see the following sections:
■
Section 8.3.1 – Using the combined power supply & battery charger to charge
the battery when it is inside the camera on page 28
■
Section 8.3.2 – Using the combined power supply & battery charger to charge
the battery when it is outside the camera on page 29
■
Section 8.3.3 – Using the stand-alone battery charger to charge the battery on
page 30
8
Publ. No. 1558299 Rev. a200 – ENGLISH (EN) – February 12, 2007 27
8 – Operating the camera