8.3.1 Using the combined power supply & battery charger to charge the
battery when it is inside the camera
NOTE
For the clarity of the procedure, the ‘combined power supply & battery charger’ is
called ‘power supply’ below.
Procedure
Follow this procedure to use the power supply to charge the battery when it is inside
the camera:
To open the battery compartment lid, push down the locking mechanism.1
Push the battery into the battery compartment.2
Push the battery compartment lid into position.3
On the battery compartment lid, open the rubber lid to find the connector
on the battery.
4
Connect the power supply cable plug to the connector on the battery.5
Connect the power supply wall plug to a wall outlet box.6
Disconnect the power supply cable plug when the green light of the battery
condition indicator is continuous.
7
NOTE
The battery has a battery condition indicator. When the green light is continuous, the
battery is fully charged.
SEE ALSO
For information about the battery condition indicator, see section 5.6 – Battery
condition indicator on page 17.
■
■
For information about how to install and remove the battery, see section 8.1 – In-
stalling the battery on page 25 and section 8.2 – Removing the battery on page 26.
8
28 Publ. No. 1558299 Rev. a200 – ENGLISH (EN) – February 12, 2007
8 – Operating the camera
To Next Page
Loading...
