FLIR M100SERIES - Flush Mounting the Keypad

Flushmountingthekeypad
Flushmountingprovidesasleekinstallationwheretheproductanddashareush,
withonlythebuttonsandRotarycontrollerprotrudingfromthedash.Flushmounting
requiresthemountingsurfacetoberebated.
1.Checktheselectedlocationfortheunit.Aclear,atareawithsuitableclearance
behindthepanelisrequired.
2.Beforemodifyingthemountingsurface,refertothedimensionssuppliedinthis
documenttoensurethereisenoughspacefortheunitandallcables.
3.Fixthesuppliedmountingtemplatetotheselectedlocation,usingmaskingorself
adhesivetape.
4.Drill4holesasindicatedonthemountingtemplatetoacceptthexings.
5.Usingasuitableholesaw(thesizeandpositionisindicatedonthetemplate),make
aholeineachcornerofthecut-outarea.
6.Usingasuitablesaw,cutalongtheinsideedgeofthecut-outline.
7.UsingaRouter,followtheFlushmountrebateline,tocutoutarebatetothe
speciedrebatedepth,asindicatedonthetemplate.
8.Ensurethattheunittsintotheremovedareaandthenremoveroughedges.
9.Placethesuppliedgasketontotherearofthekeypad,ensuringthemounting
holesarealigned.
10.Connecttherelevantcablestotheunit.
11.Placethekeypadintotherebateandsecureusingthexingsprovided.
Note:Theappropriatetighteningtorqueanddrillbitsizetousedependsonthe
thicknessofthemountingsurfaceandthetypeofmaterialitismadefrom.
Note:Thesuppliedgasketprovidesasealbetweentheunitandasuitablyatand
stiffmountingsurfaceorbinnacle.Thegasketshouldbeusedinallinstallations.It
mayalsobenecessarytouseamarine-gradesealantifthemountingsurfaceor
binnacleisnotentirelyatandstifforhasaroughsurfacenish.
60