Operation
5
5.4 Visible Spectrum Camera
Figure 5.3 Visible Spectrum Digital Camera Image
1. Long press the power button to switch the TG275 ON.
2. Select the Visible Image mode in the menu system (under Image Adjust-
ments/Image Mode).
3. Point the camera toward the test area and scan as desired.
4. View the image on the display, see Figure 5.3.
5.5 Capture, View, Transfer, Send, and Delete Camera Images
1. To capture a camera image to the TG275 internal memory, pull and re-
lease the trigger. Note that an image cannot be saved if a USB cable is
connected to the TG275.
2. After a successful image capture, a display confirmation will briefly appear
showing the image filename.
3. To view images on the TG275 display, access the Gallery mode in the
main menu. In the Gallery, scroll through the stored images with the ar-
rows and open an image with the MENU button.
4. To delete images, select the DELETE or DELETE ALL FILES command to
erase the selected image or all of the stored images.
5. To transfer images to a PC, connect the TG275 to a PC using the supplied
USB-C cable. The USB jack is located at the top of the TG275 under the
flap. Once connected to the PC you can use the TG275 as you would any
external storage drive. Note: Device is not 100% compatible with Mac OS,
please do not format TG275 internal memory via Mac OS.
6. To transmit images via Bluetooth®, see Section 7, Bluetooth® Communi-
cation and FLIR Tools™.
#NAS100009; r. AJ/63868/63869; en-US
9
To Next Page
Loading...
