ON key: Power On OFF key: Power off
BRI+ KEY: brightness +,10 grade in total
BRI- KEY: /brightness -,10 grade in total
B/PU key: slow animation blue/purple
G/YE key: slow animation green/yellow
B/CY key: slow animation blue/cyan
R key: static red color G key: static green color
B key: static blue color WHT key: static white color
YE key: static yellow color (R+G)
CY key: static cyan color (G+B)
PU key: static purple color (R+B)
Rainbow key: multiple colors gradual changing
Four seasons key: multiple colors fade changing
DISCO key: multiple colors flash changing
PARTY key: multiple colors jump changing
4.RGBW / RGB External control mode (12V/24VDC ,5 / 4 wires out )
IMPORTANT: This section only applies to the RGBW/RGB lights with 5/4 wires out ,12VDC or
24VDC. pool operators can choose to install controllers to build a fine control system .
The specification of the controller and the power supply , especially the input voltage ,must be
well known by the users and installers before installation .Failure to do so may cause the injury
to person and damage to the lights system .
Installation
All lamps should be placed on the wall of the pool at approximately 700mm below the water
surface, in areas that are easily accessible from the upper edge of the pool.
This LED bulb is fitting to PAR56 niches and for replacing the PAR56 directly. Refer to the below
pictures:
1. 2. 3.1
4.1 3.2 4.2
5 6
Warranty
The manufacturer warrants this resin filled LED underwater lights against defects in materials
and workmanship for a period of two years from the date of purchase. This warranty does not
cover the fixture becoming damaged due to misuse, accidental damaged, improper handling
and/or installation and specifically excludes liability for direct, incidental damages.
WARNING: Frequent voltage fluctuations can irreparably damage the lamp.
If the installation must take place in areas where these changes may be frequent, a system to
protect the lamps must be installed on the electric system of the pool.
Don’t use electronic transformers which may damage the light. You should use
industrial frequency transformer , such as toroidal transformer and square transformer .
To Previous Page
Loading...