7
Finishing the leash end:
• Tighten the knot. Cut excess cord o with scissors.
• Melt the end of the knot with a lighter. While the end
is still soft/melted, use the edge of the lighter to at-
ten and shape the end of the knot onto the rest of the
knot. This ensures the knot will not come undone.
Tip: If the melted plastic sticks to the lighter, it’s too hot. Wait a second before shaping it.
FLOWCORD AND KNOB-LEASH
Your knob-leash comes with a pair of poi knob handles, washer and adjustable owcord
leash. Crystal darts include a 10’+ leash, also made of owcord.
ADJUSTING THE LENGTH OF YOUR KNOB-LEASH
Adjusting your leash to t your body and style is an easy and important step to optimizing
your poi experience.
Loosen the knot on the end with the extra cord, and move the position of the knot to
lengthen or shorten your leash. Test the length and adjust as needed - a popular length
for poi is from hand to shoulder. Tighten the knot and nish your leash (see instructions
below). The result is a high performance leash with minimal hardware or knots.
ATTACHING FLOWLEASH TO CRYSTAL CASES
Your crystal poi should come with your leash assembled to the crystal case.
If you need to re-assemble your leash, thread owcord through the provided metal o-ring
and then through the crystal case. O-ring should be on the handle side of the leash.
• Thread the non-handle end of ow-
cord through the ring as shown.
• Adjust leash length as needed.
• Tie a simple overhand knot on the
non-handle end to secure the leash.
To Next Page
Loading...