SPYDR
USER MANUAL
SPYDRx Series systems are passively cooled with
zero moving components. They are designed for
harsh environments and years of maintenance-free
performance. Some basic care will keep your system
operating at peak performance cycle-after-cycle.
QNatural convection removes heat away from the
heatsink. In order for the system to properly cool
itself, at least one inch of space is required between
the console and the roof of your grow area.
Failure to do so may shorten the fixture’s lifespan.
QTo achieve the optimal lifespan and performance
of your fixtures, routinely check for and remove
excess dust, debris, and mineral build up
from heatsink and LED array.
QCleaning should always be done with the fixture
unplugged from its power source using low-pres-
sure compressed air or water to rinse away dirt from
light bars.
QNever use a cloth to clean the diode array. Doing
so can scratch or compromise the integrity of the
silicon seal, or dislodge diodes entirely.
QTo limit degradation, avoid touching the diodes
with your hands, even in a powered o state.
GENERAL CARE
To Next Page
Loading...