Power Logger
Measuring Functions
11
Connecting the Logger to the Network
XWWarning
To prevent the risk of electric shock, when
connecting current circuits, the corresponding test
leads must first be connected to the Logger and then
to the load.
To prevent shock or personal injury, keep fingers
behind the tactile barrier, see Figure 4.
Note
When using either flexi-probes or current clamp sets, make sure the
arrow on the current probe points towards the load.
Use the original cables only for connecting the current probes and the voltages
to the Logger. If these are damaged do not use them. Before connecting to the
load, make sure that all plugs are connected correctly to the Logger and
locked, in order to prevent contact with live conductors.
Single Insulated
Current Carrying
Conductor
600 V CAT III
i5s
AC CURRENT CLAMP
SERIAL NUMBER
Tactile Barrier
Load Direction
Arrow
Release
Button
edx045f.eps
Figure 4. Using the Optional Microclamps
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
