Fluke 5520A - Page 408

5520A
Operators Manual
E-2
101 (DDE:FR D) Inguard not responding (recv)
102 (DDE:FR D) Lost sync with inguard
103 (DDE:FR ) Invalid guard xing command
104 (DDE:FR D) Hardware relay trip occurred
105 (DDE:FR D) Inguard got impatient
106 (DDE:FR D) A/D fell asleep
107 (DDE:FR D) Inguard watchdog timeout
108 (DDE:FR ) Inguard is obsolete
109 (DDE:FR D) Inguard parity error
110 (DDE:FR D) Inguard overrun error
111 (DDE:FR D) Inguard framing error
112 (DDE:FR D) Inguard fault error
113 (DDE:FR D) Inguard fault input error
114 (DDE:FR D) Inguard fault detect error
115 (DDE:FR D) Inguard read/write error
300 (DDE: ) Invalid procedure number
301 (DDE: ) No such step in procedure
302 DDE: ) Can’t change that while busy
303 (DDE: ) Can’t begin/resume cal there
304 (DDE: ) Wrong unit for reference
305 (DDE: ) Entered value out of bounds
306 (DDE: ) Not waiting for a reference
307 (DDE: ) Continue command ignored
308 (DDE:FR ) Cal constant outside limits
309 (DDE:FR ) Cal try to null failed
310 (DDE:FR D) Sequence failed during cal
311 (DDE:FR D) A/D measurement failed
312 (DDE:FR ) Invalid cal step parameter
313 (DDE: ) Cal switch must be ENABLED
314 (DDE:FR ) Divide by zero encountered
315 (DDE:FR ) Must be in OPER at this step
316 (DDE:FR ) Open thermocouple for RJ cal
317 (DDE:FR ) Bad reference Z or entry
318 (DDE:FR ) Cal takes DAC over top limit
319 (DDE: R ) Zero cal needed every 7 days
320 (DDE: R ) Ohms zero needed every 12 hours
398 (QYE:F ) Unusual cal fault %d
399 QYE:F ) Fault during %s
400 (DDE:FR D) Encoder not responding VERS
401 (DDE:FR D) Encoder not responding COMM
402 (DDE:FR D) Encoder not responding STAT
403 (DDE:FR ) Encoder self-test failed
405 (DDE:FR ) Message over display R side
406 (DDE:FR ) Unmappable character #%d
407 (DDE:FR ) Encoder did not reset
408 (DDE:FR ) Encoder got invalid command