Fluke 5520A - Page 412

5520A
Operators Manual
E-6
1062 (DDE:FR ) A5 1 Mohm reference fault
1063 (DDE:FR ) A5 2W comp open ckt fault
1064 (DDE:FR ) A5 2W comp fault
1065 (DDE:FR ) A7 Shunt amp fault (2.2A)
1066 (DDE:FR ) A7 Shunt amp fault (3.3 mA)
1067 (DDE:FR ) A7 Shunt amp fault (33 mA)
1068 (DDE:FR ) A7 Shunt amp fault (330 mA)
1069 (DDE:FR ) A7 Shunt amp fault (11A)
1070 (DDE:FR ) A7 Leakage current fault
1071 (DDE:FR ) A7 Output amp leakage fault
1072 DDE:FR ) A7 Undercurrent fault +3.3 mA
1073 (DDE:FR ) A7 Overcurrent fault +3.3 mA
1074 (DDE:FR ) A7 Undercurrent fault -3.3 mA
1075 (DDE:FR ) A7 Overcurrent fault -3.3 mA
1076 (DDE:FR ) A7 Undercurrent fault +33 mA
1077 (DDE:FR ) A7 Overcurrent fault +33 mA
1078 (DDE:FR ) A7 Undercurrent fault -33 mA
1079 (DDE:FR ) A7 Overcurrent fault -33 mA
1080 (DDE:FR ) A7 Undercurrent fault -330 mA
1081 (DDE:FR ) A7 Overcurrent fault -330 mA
1082 (DDE:FR ) A7 Undercurrent fault +330 mA
1083 (DDE:FR ) A7 Overcurrent fault +330 mA
1084 (DDE:FR ) A7 Undercurrent fault -2.2A
1085 (DDE:FR ) A7 Overcurrent fault -2.2A
1086 (DDE:FR ) A7 Undercurrent fault +2.2A
1087 (DDE:FR ) A7 Overcurrent fault +2.2A
1088 (DDE:FR ) A7 Aux amp fault
1089 (DDE:FR ) A7 Monitor fault (+DC)
1090 (DDE:FR ) A7 Monitor fault (-DC)
1200 (DDE:FR ) Sequence name too long
1201 (DDE:FR ) Sequence RAM table full
1202 (DDE:FR ) Sequence name table full
1300 (CME: R ) Bad syntax
1301 (CME: R ) Unknown command
1302 (CME: R ) Bad parameter count
1303 (CME: R ) Bad keyword
1304 (CME: R ) Bad parameter type
1305 (CME: R ) Bad parameter unit
1306 (EXE: R ) Bad parameter value
1307 (QYE: R ) 488.2 I/O deadlock
1308 (QYE: R ) 488.2 interrupted query
1309 (QYE: R ) 488.2 unterminated command
1310 (QYE: R ) 488.2 query after indefinite response
1311 (DDE: R ) Invalid from GPIB interface
1312 (DDE: R ) Invalid from serial interface
1313 (DDE: R ) Service only