Remote Commands
Use of *OPC?, *OPC, and *WAI 6
6-13
Table 6-6. Command Summary (cont.)
Instrument Configuration Commands
FORMAT
Restores calibration constants and setups to factory defaults. Use with extreme
care.
GWADDR Sets gateway address
GWADDR? Returns the gateway address.
IPADDR Sets IP address
IPADDR? Returns the IP address
MACADDR? Returns the MAC address.
REM_MODE Sets computer/terminal mode for given port.
REM_MODE? Returns the computer/terminal mode for given port.
RPTSTR Sets the report string.
RPTSTR? Returns the report string.
SH Load or create a shunt
SH? Shows the data for a current shunt.
SH_AC? Returns the AC/DC difference correction points for selected shunt.
SH_ACADD Adds an AC/DC difference data point.
SH_ACCLR Clears all of the shunt AC/DC difference corrections.
SH_ACDEL Deletes a shunt AC/DC difference correction.
SH_ACMOD Sets a shunt AC/DC difference correction to a new frequency & error.
SH_ACSETALL Sets all shunt AC/DC difference corrections at once.
SH_CLR Disables/exits current shunt measurement window.
SH_DCERR Sets DC ppm error for the selected shunt.
SH_DCERR? Returns the DC ppm error for the selected shunt
SH_DELE Clears shunt data for a particular serial number.
SH_LDGEN Loads generic shunt data for a value of shunt.
SH_LIST? Lists serial numbers available for a value of shunt.
SH_LISTALL? Lists all shunt serial numbers available.
SH_LE? Returns the loading error correction points for selected shunt.
SH_LEADD Adds a loading error correction.
SH_LECLR Clears all of the loading error corrections.
SH_LEDEL Deletes a loading error correction.
SH_LEMOD Sets a loading error correction to a new frequency & error.
SH_LESETALL Sets all loading error corrections at once.
SH_LOAD Loads the shunt data from a particular serial number.
SH_SAVE Saves the shunt data.
To Next Page
Loading...
