5790B
Operators Manual
6-14
Table 6-6. Command Summary (cont.)
Instrument Configuration Commands
SH_SERNUM Sets the serial number of loaded shunt.
SH_SERNUM? Returns the serial number of the selected shunt.
SH_TYPE? Returns the type of the selected shunt.
SP_SET Programs serial port nonvolatile settings.
SP_SET? Returns the serial port nonvolatile settings.
SUBNETMASK Sets subnet mask
SUBNETMASK? Returns the subnet mask
WBAF Sets whether to correct for the AF option wideband cable.
WBAF? Returns the whether instrument is correcting for the AF option wideband cable.
WBAFOPT Sets the correction for the AF option wideband cable.
WBAFOPT? Returns the correction for the AF option wideband cable.
Measurement and Transfer Commands
DBM? Returns 50 Ω dBm power equivalent of reading. This is valid only for wideband.
DELTA? Returns the delta (transfer) value from the Product.
DFILT Sets the digital filter parameters for mode and restart.
DFILT? Returns the digital filter parameters for mode and restart.
DUNIT Sets the delta unit value.
DUNIT? Returns the delta unit value.
HIRES Enables and disables higher resolution amplitude display.
HIRES? Returns the setting of the HIRES command.
INPUT Selects the active input terminal.
INPUT? Returns the active input terminal.
MEAS?
Triggers (or in continuous trigger, re-triggers) a new measurement, waits for it to
complete, then retrieves the value of the present input measurement (the most
recently completed input measurement). This is equivalent to the following
sequence of commands: TRIG; *WAI; VAL?
MW?
Returns the 50 Ω milliwatt power equivalent of reading. This is valid only for
wideband.
PKPK? Returns the peak-to-peak power equivalent for requested waveform.
RANGE
Selects the range that best measures the specified value. The range selected is
the one within whose limits (as returned by the RANGE? command) the value
falls. This command turns off autoranging if it was on.
RANGE? Returns the present measurement range characteristics.
REF? Returns the reference value and its associated parameters.
REFAVG
Sets the reference to the average of the present reference value and the present
input measurement; this is valid only if the reference has already been set and
averaging hasn't been done since it was set.
To Next Page
Loading...
