Remote Commands
Use of *OPC?, *OPC, and *WAI 6
6-15
Table 6-6. Command Summary (cont.)
Measurement and Transfer Commands
REFCLR Clears the reference.
REFSET Sets the reference to the value of the present input measurement.
STATS Turns measurement statistics ON or OFF.
STATS_PAUSE Pauses statistics collection underway.
STATS_RESUME Resumes statistics collection from a pause.
STATS_STOP Stops collecting statistics.
STATS_COUNT Sets number of samples included in the statistics.
STATS? Reports statistics.
STATUNIT Sets unit for sigma in statistics.
STATUNIT? Retrieves unit for sigma and span in statistics.
TRIG
Triggers a measurement. When the Product is in manual trigger mode, it begins a
measurement when it receives the *TRG, TRIG, or MEAS? command.
UNCERT? Returns the present input measurement uncertainty in ppm.
VAL?
Returns the value of the present input measurement (the most recently completed
input measurement).
Serial/USB/Ethernet Remote Mode only Commands
LOCAL Sends to local state (IEEE-488 GTL function).
LOCKOUT Sends to lockout state (IEEE-488 LLO function).
REMOTE Sends to remote state. (IEEE-488 REN and GTL functions).
SPLSTR Sets the Serial Mode Serial Poll response string.
SPLSTR? Returns the string used for Serial/USB/Ethernet Mode Serial Poll responses.
SRQSTR Sets the Serial/USB/Ethernet Mode SRQ response string.
SRQSTR? Returns the string used for Serial/USB/Ethernet Mode SRQ responses.
Status Commands
ISCE0 Sets the Instrument Status One To Zero Change Enable register
ISCE0?
Returns the contents of the Instrument Status One To Zero Change Enable
register.
ISCE1 Sets the Instrument Status Zero To One Change Enable register.
ISCE1?
Returns the contents of the Instrument Status Zero To One Change Enable
register.
ISCR0? Returns the contents of the Instrument Status One To Zero Change Register.
ISCR1? Returns the contents of the Instrument Status Zero To One Change Register.
ISR? Returns the contents of the Instrument Status Register.
To Next Page
Loading...
