Appendices
Error Codes A
A-7
1201 Error setting GPIB Primary Address
1202 Error occurred reading characters from GPIB controller
1203 Error occurred sending characters to the GPIB controller
1204 GPIB DOS Error
1205 GPIB specified Interface Board is not Active Controller
1206 GPIB no present listening devices
1207 GPIB interface Board has not been addressed properly
1208 GPIB invalid argument
1209 GPIB specified Interface Board is not System Controller
1210 GPIB I/O operation aborted (time-out)
1211 GPIB non-existent GPIB board
1212 GPIB routine not allowed during asynchronous I/O operation
1213 GPIB no capability for operation
1214 GPIB File system error
1215 GPIB command byte transfer error
1216 GPIB serial poll status byte lost
1217 GPIB SRQ stuck in ON position
1218 GPIB table problem
1300-Level Faults: Remote interfaces
1300 Bad Syntax
1301 Unknown command
1302 Bad Parameter Count
1303 Bad Keyword
1304 Bad Parameter Type
1305 Bad Parameter Unit
1306 Bad Parameter Value
1307 488.2 I/O DEADLOCK
1308 488.2 INTERRUPTED Query
1309 488.2 UNTERMINATED Command
1310 488.2 Query After Indefinite Response
1311 Invalid From GPIB Interface
1312 Invalid From Serial Interface
1313 Unknown command
1314 Parameter Too Long
To Next Page
Loading...
