5790B
Operators Manual
4-4
Setup Menu
Setup Menu Softkey
Push the Setup Menu softkey to call up the top-level utilities menu, which
provides softkeys for calibration, diagnostics, instrument setup, system settings
and measurement control. Most parameters are saved in memory until they are
changed, including power-off periods. See Tables 4-1 and 4-2 for a summary.
When you push Setup Menu, the display shows the top-level utilities menu:
2/11/15 10:52am Setup
Input 2 2.0000064 V
Exit
Calibration
Zero cal
DC cal
AC cal
Change Cal Passcode
View/Update Cal Dates
System Settings
Date/Time Format
Brightness
Emulation
Remote Port
Self Test & Diagnostics
Diagnostics
Key and Bell Tests
Instrument Setup
Current Shunt Details
Digital Filter Setup
Initial Input Choice
Hi Res Mode
Calibration Interval
Setup Menu
About This Instrument
hvi020.eps
The list below describes submenus accessed through each softkey and tells you
where to find further information in the manuals.
• Calibration: Opens the calibration menu. Softkeys in this menu execute dc
zeros calibration, as previously described, and control the semi-automated
calibration procedure. Items in this menu: show calibration date information
and change the calibration passcode (after you unsecure the Product by
entering the current passcode). DC zeros calibration is described earlier in
this chapter.
• System Settings: This menu contains softkeys to set up the remote ports, set
the clock, control instrument brightness, and set the instrument emulation
mode. System Settings Menu describes how to use these softkeys.
• Instrument Setup: This menu contains softkeys to open submenus that let
you change the calibration interval, control the Digital Filter (a software
window-averaging filter), select either INPUT 1 or INPUT 2 as the initial input,
and select Hi Res mode. This menu also contains the Current Shunt Details
menu used to add, edit, and remove current shunt information. Refer to
Instructions for Current Measurements for more information.
To Next Page
Loading...
