Front Panel Operation
Setup Menu 4
4-5
• Self Tests & Diagnostics: Opens the self tests and diagnostics menu. This
menu contains softkeys to execute the power-up tests/instrument diagnostics,
and interactive tests for verifying the bell and keys. Push at any time to
abort the diagnostic tests.
• About This Instrument: Accesses a menu that shows a list of installed
hardware modules and software version numbers.
Checking Instrument Configuration
To view the instrument configuration information:
1. Push Setup Menu>About This Instrument softkey. The display shows:
Software Information:
• Main SW Version
• Inguard SW Version
• Serial Number
And
Hardware Information:
• Installed Hardware Assemblies
2. Push the Software Information softkey to view the software version. The
"Main” software revision refers to software in flash on the A20 CPU
assembly. The "Inguard" software revision refers to software in flash on the
A17 Guard Crossing/Regulator assembly. Other various revisions/dates are
shown for different devices in the Product. Push the Exit softkey to exit this
screen.
3. Push the Hardware Information softkey. This shows the options installed in
your Product. Push the Close softkey to exit this screen.
4. To resume operation, push the Exit softkey.
System Settings Menu
The submenus in the Setup menu (accessed by pushing the System Settings
softkey in the Setup menu) contain:
Date/Time:
Accesses softkeys that allow you to check and set the date and time for the
clock/calendar. This section describes how to set the time and date under the
heading Setting the Internal Clock/Calendar.
Brightness:
Adjust the display brightness.
Emulation:
Emulates a 5790A over the remote interface. This changes the model number in
the *IDN? response. This menu is self-explanatory.
Remote Port:
Chapter 5 describes how to set up the IEEE-488 interface, USB, Ethernet and
RS-232 serial interface.
To Next Page
Loading...
