Remote Operation
Ethernet Interface 5
5-9
Configure the General Network Socket Port
To communicate with each other, a client computer and the Product must use the
same socket port number. The default port is 3490. Typically, the default port
does not need to be changed. If the socket port must be changed, enter the
Socket Port number supplied by the network administrator.
To change the Socket Port number:
1. Touch Setup Menu>System Settings>Remote Port>Ethernet Setup to get
to the Ethernet Setup menu.
2. Touch PORT.
3. Use the numeric keypad to enter a new port number.
4. Push Done. The port number must be between 1024 and 65535.
If you make a mistake when the socket port is entered, push Cancel and go to
step 3 to enter the port number again.
Note
The Network Socket Port Number is stored in non-volatile memory.
Configure the LAN Default Gateway
The default gateway IP address is the IP address of a gateway (router) attached
to the same network as the device. When the Product detects that a client
computer is not on the same network (using the network number), the data is
sent through the gateway to reach the host computer.
The default for the Product is “0” (no gateway, and subnetting is not being used).
To set the LAN Default Gateway address:
1. Do steps 1 and 2 from Select the Dynamic Host Configuration Protocol
(DHCP).
2. Touch Gateway.
3. Use the numeric keypad to enter the gateway address and then push Done.
If you make a mistake when the gateway address is entered, push Cancel and
go to step 3 and enter the address again.
To Next Page
Loading...
