Pressure Controller/Calibrator
Controller Settings (Setup Menu)
25
Remote Port Menu
Use the Remote Port menu to change or view the USB, GPIB, RS-232, and
Ethernet port settings explained in Table 6.
Table 6. Remote Port Menu
Tab Description
USB Setup
Use this menu to change the remote interface (Remote IF) to be from a Computer
or Terminal. The End of Line character (EOL) can be specified as Carriage Return
(CR), Line Feed (LF), or Carriage Return and Line Feed (CRLF).
RS-232 Setup
Use this menu to specify the RS-232 communication parameters. The editable
parameters are:
• Data Bits
• Stop Bits
• Flow Control
• Parity
• Baud
• EOL
• Remote IF
• Set EOF
• Touch Defaults to reset the RS-232 port to its default values.
Emulation Mode
From this menu, and with remote commands, the Product can emulate a variety of
different instruments. Refer to the Remote Programmers Manual on the Product CD
for a list of emulated products.
GPIB (IEEE-488)
Address
Specify the GPIB Address from this tab. Touch the tab and use the numeric keypad
on the Product or PC to change the address.
Ethernet Setup
Use this menu and the numeric keypad or PC keypad to specify or edit these
parameters:
• Host Name
• IP Address
• Gateway
• Subnet Mask
• DHCP (ON or OFF)
• Remote IF (interface)
• Port
External 24 V
Menu
Use this menu to select which driver port on the rear of the Product is in use. See
External Driver Configuration for more information.
To Next Page
Loading...
