Fluke 6270A - Turn on the Product; Warm-Up; Main Menu

Pressure Controller/Calibrator
Turn on the Product
31
Turn on the Product
To turn on the Product, turn on the main power switch, located on the left-rear of
the Product when looking at it from the front. When the Product is turned on, it
takes approximately 50 seconds to complete its power-up process. Push  on
the front right side of the Product.
Note
Push  to place the Product into standby at any time.
For the Product to perform to listed specifications, a warm-up period
is required after the Product is turned on or when a new PMM is
installed.
After the power-up process, the Product shows the Main menu (see Figure 5).
huo001.jpg
Figure 5. Main Screen
Warm-up
For the Product to perform to the specifications listed in this manual, a 15-minute
warm-up period is required after the Product is turned on. Additional ambient
temperature acclimation can be required.
Main Menu
Use the Main menu to access functions and menus are accessed. Refer to Table 9
for information about each Main menu item. The submenus for Control Settings,
Graph, and Tasks are in Tables 10, 11, and 12.