Reference Multimeter and 8 ½ Digit Multimeter
Instrument Setup
97
Instrument Setup
Once the Product is on, push to show the Instrument Setup. Before you
use the Product, use the Instrument Setup menu to set the Product up according
to your preferences. The display shows the Instrument Setup information:
• Model
• Serial Number
• Firmware
Submenus from Instrument Setup are accessed with each softkey (
through ):
• (Reset Instrument): Push this softkey to reset the Product to the
default settings, except these settings which are retained:
o Line Frequency and Ext. Ref. Clk ( > Instrument Settings)
o All settings under > Display settings
o All remote settings ( > Remote settings) except that
Emulation defaults to None on power cycle and instrument reset
o Calibration constants
o Zero values including the use of Zero
• (Instrument Settings): Includes the Display Settings menu, Line
Frequency selection (Auto, 50Hz, 60Hz), and Ext Ref Clk (OFF, 1MHz, or
10MHz).
• (Remote Settings)
• (Cal Adjust)
• (Diagnostics)
Each of these menus can be used to change make changes to the way the
Product is set up. These menus are explained in the next sections.
To Next Page
Loading...
