Reference Multimeter and 8 ½ Digit Multimeter
More
53
Connect a Power Sensor to the Product
To connect the power sensor interface cable multiway connector to the Product:
1. Remove the plastic cap from the cable-end connector and save it for future
use.
2. Connect the multiway connector to the EXT PORT on the Product. Push
firmly on the multiway connector until it latches. See Figure 15.
The presence of a sensor at the Ext. Port is automatically detected. Only
compatible sensor models are recognized. There may be a slight delay between
the connector insertion and completion of the automatic detection process.
iei337.jpg
Figure 15. Connect a Power Sensor to the Product
To Next Page
Loading...
