Need help?Do you have a question about the Fluke Biomedical Index 2MF and is the answer not in the manual?
General| Brand | Fluke |
|---|---|
| Model | Biomedical Index 2MF |
| Category | Medical Equipment |
| Language | English |
Describes the simulator's ability to verify pulse oximeters and test optical sensors.
Lists key features of the Index 2MF simulator, including simulation capabilities and portability.
General safety precautions for using the simulator and connecting peripherals.
Instructions for connecting and using the simulator's finger probe.
Describes the patented optical 'finger' used for testing oximeters.
Explains programmable simulation parameters like SpO2 and pulse rate.
Explains how to interpret test results using the simulator as a transfer standard.
Details the options and softkeys available in Main Menu 1.
Details options for oximeter selection, configuration, and display.
Explains how to configure the simulator to match specific oximeter makes.
Step-by-step guide to accessing the Make selection menu.
Guide to creating custom configurations for unsupported oximeter makes.
Instructions for accessing the Simulations menu.
Details the options within the Simulations menu.
Instructions for raising or lowering the simulated O2 saturation level.
Instructions for adjusting the simulated pulse rate.
Details the 24 pre-defined patient conditions with parameters.
Instructions for setting alarm limits for SpO2 and pulse rate.
Instructions for setting oxygen limits and timing alarm response.
Instructions for setting pulse rate limits and timing alarm response.
How to set pulse amplitude limits and test oximeter response.
How to simulate a no-pulse condition and measure alarm response time.
Overview of pre-defined and custom automated test programs.
Steps for defining, running, or changing test programs.
How to access the Autosequences menu for managing test programs.
Steps for creating a custom automated test program.
Procedure for running a saved automatic test program.
Information on testing oximeter probes using the simulator.
Testing pulse oximeters and probes using a PC.
Steps to generate an R-curve using a pulse oximeter and the simulator.
Procedure for creating an ASCII file and downloading R-curves.
Technical specifications for %O2, Rate, Pulse Amplitude, Battery, etc.
To Next Page
