DTX Series CableAnalyzer
Technical Reference Handbook
7-20
Table 7-1. OTDR Test Settings (cont.)
Setting Description
You can test cabling at one or all the wavelengths supported by the installed module and the
selected test limit.
Lets you remove the effects of launch and receive fibers from OTDR results. See page 7-11.
The cable end where the tester is located. Based on this set
ting, the tester labels OTDR results as
End 1 or End 2 to indicate which end of the cabling you tested.
Names you assign to the ends of the cabling. The nam
es are saved with OTDR results.
These settings app
ly only in Manual OTDR mode. See “Using Manual OTDR Mode” on page
7-48.
Wavelength
Note
If you
select the dual-wavelength setting, be sure to select a fiber type and test limit that
supports both wavelengths.
Launch Compensation
Testing From
End 1, End 2
Range
A
veraging Time
Pulse Width
Loss Threshold
To Next Page
Loading...
