Verifying Network Service
Pinging Network Devices
11-11
11
Pinging Network Devices
The ping test verifies connectivity to devices on the
network.
To ping a network device:
1
Enter ping addresses in Setup. See page 11-4.
2
Connect to the network as shown on page 11-7.
3
Turn the rotary switch to MONITOR, select Network
Connectivity; then press P.
4
When the network connectivity test is complete, press
L Ping.
5
Do one of the following:
•
To ping one device, highlight the device; then press
P.
•
To ping all devices in the list, press JPing All.
The overall ping result appears on the Network
Connectivity screen. A scroll bar appears if you pinged
multiple devices
6
To see ping details (Figure 11-6), highlight a device;
then press H.
7
To save the ping results, press N. Ping results are saved
as part of the connectivity results. You can save the
network connectivity results in a separate record or
with an existing cable test record. See page 11-6.
To Next Page
Loading...
