DTX Series CableAnalyzer
Technical Reference Handbook
14-4
amd178.eps
Figure 14-2. Fiber Connections for Updating the
Software with a PC
Updating with Another Tester
You can update a tester’s software using another tester
that is already updated.
1
Connect an updated tester or smart remote to a tester
or smart remote that needs updating, as shown in
Figure 14-3 or 14-4.
Note
One of the units must be a main tester.
2
Turn on both units; then press Pon either.
3
The testers compare software versions. If one has more
recent software, the main tester prompts you about
updating the older software.
4
Press K OK to start the update process.
5
To verify the update, turn the rotary switch to SPECIAL
FUNCTIONS; then select Version Information.
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
TALK
TEST
PASS
TEST
FAIL
TALK
TONE
To Next Page
Loading...
