Maintenance and Specifications
Specifications
14-13
14
WWarningX
Under no circumstances is this product intended
for direct connection to telephony inputs,
systems, or equipment, including ISDN inputs.
Doing so is a misapplication of this product, which
could result in damage to the tester and create a
potential shock hazard to the user.
Service Calibration Period
One year.
Standard Link Interface Adapters
Cat 6A/Class E
A
permanent link adapters (except
DTX-ELT and DTX-CLT)
• Plug type and life: shielded 8-pin modular (RJ45);
>5000 insertions
• Tests supported: shielded and unshielded cable, TIA Cat
3, 4, 5, 5e, 6, and 6A and ISO/IEC Class C and D, E, and
E
A
permanent link
6A/Class E
A
channel adapters
• Plug type and life: shielded 8-pin modular (RJ45);
>5000 insertions
• Tests supported: shielded and unshielded cable, TIA Cat
3, 4, 5, 5e, 6, 6A and ISO/IEC Class C, D, E, and E
A
channels
Cable Types Tested
• Shielded and unshielded twisted pair (STP, FTP, SSTP,
and UTP) LAN cabling:
• TIA Category 3, 4, 5, 5e, 6, and 6A: 100 Ω
• ISO/IEC Class C and D: 100 Ω and 120 Ω
Note
For availability of additional adapters that allow
testing to other performance standards, different
cabling types, or fiber optic cabling, contact Fluke
Networks.
Time for Autotest
Time for a full, 2-way Autotest of Category 6 UTP cable (Cat
5e for the DTX-CLT):
• DTX-1800 and DTX-1200: 10 seconds or less
• DTX-LT, DTX-ELT, and DTX-CLT: 28 seconds or less
Tone Generator Specifications
Generates tones that can be detected by a tone probe, such
as a Fluke Networks IntelliTone
™
probe. The tones are
generated on all pairs.
Frequency range of tones: 440 Hz to 831 Hz
To Next Page
Loading...
