Certifying Fiber Optic Cabling
Autotest in Loopback Mode
8-29
8
Figure 8-13. Equipment for Testing in Loopback Mode (1 Jumper Method)
amd49f.eps
A
Tester with fiber module and connector adapter
installed (match connector adapter to the connectors in
the link)
B
Memory card (optional)
C
AC adapter with line cord (optional)
D
Test reference cord. Match the fiber to be tested. Long
end must have SC connector. For the other connectors,
match the connectors in the link.
E
Two singlemode adapters of the appropriate type
F
Mandrel Recommended when testing multimode fiber
with DTX-MFM2 modules. See page 8-12.
G
Fiber cleaning supplies
H
A microscope for inspecting fiber connectors (the FT500
FiberInspector Mini Video Microscope is shown)
To Next Page
Loading...
