Fluke DTX-1800 - Using the Visual Fault Locator

DTX Series CableAnalyzer
Technical Reference Handbook
9-2
Using the Visual Fault Locator
Figure 9-1 shows the equipment needed for using the visual
fault locator.
The visual fault locator port accepts connectors with
2.5 mm ferrules (SC, ST, or FC). To connect to other ferrule
sizes, use a test reference cord with the appropriate
connector at one end and a SC, ST, or FC connector at the
tester end.
Figure 9-1. Equipment for Using the Visual Fault Locator
amd61f.eps
A Tester or smart remote with DTX-MFM2, DTX-SFM2, or
DTX-GFM2 fiber module or tester with DTX Compact
OTDR module
B AC adapter with line cord (optional)
C One test reference cord. Match fiber and connectors to
be tested; SC, ST, or FC at tester end (optional)
D Fiber cleaning supplies
1
4
3
2