Tutorials on Setup and Test Procedures
Certifying Fiber Cabling
2-13
2
Figure 2-7. Equipment for Testing in Smart Remote Mode (1 Jumper Method)
amd46f.eps
A
Tester and smart remote with fiber modules. Use
DTX-MFM2 modules for testing multimode fiber. Use
DTX-GFM2 modules for testing multimode fiber for
Gigabit Ethernet applications. Use DTX-SFM2 modules
for testing singlemode fiber.
B
Memory card (optional)
C
Two ac adapters with line cords (optional)
D
Test reference cords. Match the fiber to be tested. Long
ends must have SC connectors. For the other connectors,
match the connectors in the link.
E
Two singlemode adapters of the appropriate type
F
Two mandrels. Recommended when testing multimode
fiber with DTX-MFM2 modules. See page 8-12.
G
Fiber cleaning supplies
H
A microscope for inspecting fiber connectors (the FT500
FiberInspector Mini Video Microscope is shown)
Note
To run an Autotest without connecting to cabling,
you may connect the tester and remote together
with an SC/SC test reference cord.
To Next Page
Loading...
